Torque Rating for U-Bolts # SP01-040 for 2-3/8 inch Diameter Axles

Question

Question:

Do you have the Torque Rating for trailer u bolts?

asked by: Jim K

0

Expert Reply:

Yes the torque specs for the nuts on the U-bolt part # SP01-040 should be between 45 and 70 foot lbs.

expert reply by: Jameson C

0

Answer 1

I called the manufacturer and they said that the minimum torque is 45 ft. lbs. and the maximum is 70 ft. lbs.

view full answer...

Answer 2

The axle U-bolt torque spec will depend on the bolt diameter- • 5/16 inch- 65 ft/lbs • 1/2 inch- 45-70 ft/lbs • 9/16 inch- 65-90 ft/lbs • 5/8 inch-100-120 ft/lbs • 3/4 inch-160 ft/lbs Shackle bolts don't typically have a specific torque value.…

view full answer...

Answer 3

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 4

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...

Answer 5

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 6

Normal operating temperatures for drum brakes range from 150-400 degrees F. During certain stopping conditions the brake heat can exceed 600 degrees. The effectiveness and stopping power of the brakes is significantly reduced at these higher…

view full answer...

Answer 7

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 8

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 9

The Champion 9,000-Watt Dual Fuel Inverter Generators w/ Parallel Kit, #CH49FR has the same power output specs regardless of type fuel used. There is a starting (surge) power output of 4,500 watts/37.50 amps with a running power output of 3,500…

view full answer...

Answer 10

I recommend you only consider an inverter type generator. From the specs available to me online, your 2019 Forest River Salem 30KQBSS Travel Trailer is a 50-Amp service with 2nd A/C Prep option. If you have have the second AC unit installed or a…

view full answer...

Answer 11

The Champion 9,000-Watt Dual Fuel Inverter Generators w/ Parallel Kit, #CH49FR have a push button electric start and operate from either propane or a minimum 87 octane rating gasoline for their fuel source. Run time is up to 14 hours on gas and as…

view full answer...

Answer 12

We do have an option for an inverter to replace your 300 watt WIN-12/300TL, but the Progressive Dynamics part you mentioned is a converter, so for the same functionality you will want to replace it with a similar 400 watt inverter, the Go Power Pure…

view full answer...

Torque Rating for U-Bolts # SP01-040 for 2-3/8 inch Diameter Axles

Product Page this Question was Asked From

Continue Researching