Dimensions of Dutton-Lainson Hand Winch # DL10950
Question:
What are the dimensions of the winch body? I bought the WG2000 to raise the centerboard on my sailboat but it is rather large in size for where it is mounted.
asked by: Tom H
1
Helpful Expert Reply:
The base of the Dutton Lainson Winch part # DL10950 that you referenced are 5-3/4 inches wide and tall, and 6-3/4 inches long.
I attached a review video for this for you to check out as well.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Dutton-Lainson Hand Winch - Worm Gear - 1,500 lbs
- Trailer Winch
- Brake Hand Winch
- Utility Winch
- Standard Duty
- Standard Hand Crank
- Worm Gear Winch
- Wire Rope
- Dutton-Lainson
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Winch for Raising and Lowering a Draw Bridge
- Q&A: Split Reel Winch to Lift 350 lb 10 Feet
- Q&A: How Does Worm Gear Winch Brake Work
- Q&A: Using Worm Gear Winch Versus Brake Winch for Hoisting Small Dinghy
- Q&A: Hand Winch Recommendation for Raising and Lowering a Draw Bridge
- Q&A: Comparing Dutton-Lainson Brake vs Worm Drive Hand Winches
- Q&A: Cable Attachment and Function of the Dutton-Lainson Worm Gear Winch - 1500 lbs # DL11011
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What is Boondocking
- Article: Hand Winches
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer
- Article: Trailer Tire Sizing
- Article: Pintle-Hitches
- Article: How to Measure for Trailer Hitch Drop