Brake Controller Installation on 2007 Ford Explorer Sport Trac
Question:
My Sport Trac has factory tow package for 3500 lbs. We want to add a electric brake. i found the factory plug under the dash and purchased a pig tail to connect to it and the brake controller. We cant find where the wires coming from the front for electric brake are near the rear hitch area. Did Ford run the blue brake wire to the rear and will I have to run a separate one? thanks!
asked by: Rick
Expert Reply:
In my research, I can find no reference whatsoever to a Explorer Sport Trac being equipped with the factory tow package, so it must be a rare option. Which trailer connector does your Sport Trac have?
You can confirm that the connector under the dash is active, and that the pig tail you have had power to the black wire, and the red wire shows voltage when the brake pedal is pressed by using a circuit tester like part # PTW2993 on each wire.
If that checks out, you will need to examine the rear frame rail on the driver's side, looking for the blue brake controller output wire.
If you cannot find the wire on the frame rail, it is safe to assume that either the wire has not been ran, or that it terminates in an unknown or inaccessible location. You can sever the blue wire exiting the rear of your controller (see provided diagram), and use a length of 10 gauge wire like part # 10-1-1 to connect the brake controller output circuit to the # 2 terminal on the 7-way trailer connector.
Products Referenced in This Question
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Replacement Hub for 2013 Wildwood 26TBSS Hub Drum with AL-KO 8700
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: How to Bleed Electric Over Hydraulic Trailer Brakes
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer
- Article: Best Camper Jacks
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)