How to Turn Off 12-V Power Feed to 7-Way Trailer Connector on Vehicle When Ignition is Shut Off
Question:
If I leave my trailer connected to the truck while it is not running it drains the battery. I placed a meter on the 7 point connection and it appears the 12 volt pin is hot at all times. How does one fix this without tearing out the dashboard?
asked by: Ryan
Expert Reply:
This is very easily fixed. Simply install a battery isolation solenoid, part # PK5231201. This will disable that 12-Volt feed when the ignition is shut off. The solenoid is usually mounted in the engine compartment.
The product description overview video I've linked will run you through how to wire the solenoid. The terminal on either side is used for the incoming and outgoing power it doesn't matter which terminal is used for which and the center terminal is used to an ignition switched circuit. The radio circuit is often used, because it typically powers down when the ignition is off.
Products Referenced in This Question
Starter Solenoid - SPST - 12 Volt - 100 Amp - Continuous Duty - Grounded
- Accessories and Parts
- Battery Boxes
- Switches and Solenoids
- 100 Amp
- Pollak
more information >
Product Page this Question was Asked From
Continue Researching
- Q&A: How to Activate Trailer 12V Power Feed on Factory 7-Way in 2016 Silverado
- Shop: Suspension Enhancement
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Timbren Suspension Enhancement System - Severe Service - Rear Axle
- Q&A: Parts Needed To Add Electric Drum Brakes To A Pontoon Trailer
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Q&A: Recommended Tow Wiring for a 2023 Kia Telluride With LED Lights
- Q&A: Bypassing Factory Brake Controller and Installing Aftermarket Model on 2018 GMC Sierra 3500
- Q&A: Adding a Battery on an Enclosed Trailer to Power Interior Lights
- Q&A: Can Electric Brakes be Used on a Boat Trailer
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Q&A: What Gauge Wire Does The Curt USCAR Connector C56229 Use?
- Article: Testing Trailer Brake Magnets for Proper Function