Replacement Pitch Arm for Solera 69" Standard Flat Awning Support Arm

Question

Question:

Hello, the support bar on my 69 inch awning is a little bent causing a sag in the awning. Do you sell just this bar - see photo: I don’t need the full set up just the one piece. Can you also provide the part number for this piece? Thank you,

asked by: Grant C

0

Expert Reply:

It sounds like you are looking for a new pitch arm for the Solera 69" Standard Flat Awning Support Arm part # LC281154. If that is the case then you can replace this with the Replacement Pitch Arm Assembly for Solera 69" Standard Flat Awning Support Arm part # LC375994.

expert reply by: Conner L

0

Answer 1

When you go to install the Replacement Pitch Arm part #LC375994 you'd need to go with three of the retaining washers #LC431583.

view full answer...

Answer 2

We have two Solera struts available for Solera awnings with the part #LC280343 for if you have a short or flat awning or the part #LC260282 for if you have a pitched arm awning. The numbers you listed aren't part numbers so I wasn't able to…

view full answer...

Answer 3

I did some checking and it appears that the gas strut #LC260282 is held to the support arms with bolts, pins, or rivets that go through the eyelets at each end, see picture. It does not appear that the strut unscrews from those eyelets. The…

view full answer...

Answer 4

The correct gas strut for your powered or manual Solera awning will simply depend on which Solera awning arm assembly you have. If you have a Solera Short or Flat awning arm assembly (which will use something like the Solera Short Awning Support Arm…

view full answer...

Answer 5

Thank you for the photo; the individual rails are not available separately so you will need to get the Support Arm Assembly such as #LC281154 to replace your bent rail. This assembly has 69" support arms and is to be used with standard awning…

view full answer...

Answer 6

Thank you for the photos and that information, and based on those photos, what you will need to do is replace the awning arm altogether. For the 69 inch wall mount, the correct part is the following: - Solera 69" Standard Flat Awning Support…

view full answer...

Answer 7

I reached out to the manufacturer who told me there isn't any type of recommended way to remove the starlock washer on the Solera Gas Strut #LC260282 but that "most people shim something behind, hit and tap it with a screwdriver to pry it…

view full answer...

Answer 8

I reached out to my contact at Lippert regarding the part that you need. The only two replacement part/assemblies that they sell, for your model number, is the Lippert #LC375994 "Pitch Arm" (not the part you need) and the Lippert #LC281154…

view full answer...

Answer 9

We have replacement pitch arms for the Solera 69 inch awning setups like what you have with the part #LC375994 which would be all that you'd need.

view full answer...

Answer 10

You will want to measure the length of your current Solera awning pitch arms and match up the correct size on the link I attached for you. Based on the photo you attached, you will likely need one of the following sizes: -Replacement Pitch Arm…

view full answer...

Answer 11

I attached a picture I got from Lippert that has their install instructions and diagnosis page for the #LC375994 that you referenced.

view full answer...

Answer 12

You can reuse your current pin when installing the new Solera Pitch Arm part #LC375994 but you will need new retaining washers with part #LC431583.

view full answer...

Replacement Pitch Arm for Solera 69" Standard Flat Awning Support Arm

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching