Replacement RV Key for Code CF332

Question

Question:

Looking for replacement key for 2013 Forest River Toy Hauler You show HF332 replacement however, number on my key is CF332 Will it work?

asked by: Dave T

0

Expert Reply:

The replacement key part # GL26FR is the correct key as it fits the key codes FIC HF, EF, and CF codes.

expert reply by: Jameson C

0

Answer 1

I spoke to my contact at Camco and he informed me that the warranty for the Camco RV Heated Drinking Water Hose #CAM22903 is 36 months from the date of purchase. Also, my contact wanted me to mention that this product has a self regulating heat…

view full answer...

Answer 2

The correct replacement key you need for a Fastec Industrial Corp. (FIC) Lock with 315 lock cylinder is the Replacement Key for FIC Locks part #GL54FR.

view full answer...

Answer 3

Since the lights and fan in your Everchill WD-282FWDC Refrigerator #324-000119 work but the compressor does not appear to be performing its cooling duties I suspect you may have a power issue. The compressor will not operate unless it sees at least…

view full answer...

Answer 4

There may be a solution for you with the Global Link RV Entry Door Locking Latch Kit #295-000019. This is a replacement for a standard entry door lock from a number of manufacturers including Fastec (FIC). It is 3.47" wide x 4.28" tall,…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 9

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 10

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 11

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 12

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Replacement RV Key for Code CF332

Product Page this Question was Asked From

Continue Researching