Hitch Pin Hole Size of Curt Trailer Hitch Receiver 11276
Question:
On Curt hitch C11276, is the hitch pin size 1/2 inch? Do you stock this hitch?. Thank you
asked by: Doug M
0
Expert Reply:
You are correct about the hitch pin hole size of the Class I Curt Trailer Hitch Receiver # C11276 being 1/2 of an inch. This is true of all trailer hitches that have a 1-1/4 inch receiver like this hitch does.
I have added a link to the directions, as well as some video installs for you to check out of the Curt Trailer Hitch Receiver # C11276.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How Much Upward Bend Should Trailer Axle Have
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: How Far Back Should Thule Mounting Feet Be Placed On a 2019 Toyota Highlander with Bare Roof
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What Should Tire Pressure be for a Load Range G 110 psi Tire
- Q&A: What is the Difference Between 7-Way RV and Utility Trailer Connectors
- Q&A: Recommended RV Exterior Ladder for 22 Ft Thor Four Winds RV
- Q&A: Do all Fifth Wheel Rails have the Same Dimensions
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: Rust Prevention
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Hitch Receiver Sizes
- Article: Electric Brake Controller Installation on Dodge Ram Trucks to 2012