Troubleshooting Hitch Bolts That Wont Thread Into Weld Nuts on 2012 Toyota Venza
Question:
The bolts received with hitch dont seem to fit the welded nuts on my 2012 Venza. I dont want to force them and cross thread. I tried the hardware store going down in size to a 8mm but it slips right through the nut. Suggestions?
asked by: Paul
Expert Reply:
If you haven't already, I would recommend taking a nylon brush and some spray lubricant like the LubriMatic # L11474 and clean out the weld nut holes on your Curt # C12341 hitch. There could be some built up rust, dirt or other debris that is clogging up the holes and keeping you from getting them into the holes-these should thread by hand at the start.
If you've already tried this step, please let me know and I can recommend some alternative steps.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Installation Process for 4-Pole Trailer Wiring Harness 118482 in 2009 Toyota Venza
- Q&A: Does Exhaust have to be Lowered to Install Curt Trailer Hitch on a 2012 Toyota Venza All-Wheel Drive
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Hitch Installation Tips
- Q&A: Size of Factory Bolts For Installation of Curt Trailer Hitch Receiver in Factory Weldnuts
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Hitch and Wiring Harness for 2015 Toyota Venza
- Q&A: Draw-Tite 75663 Install Process for Local Mechanics or Shops
- Q&A: Recommended Trailer Hitch and Accessories for Towing 5 x 8 Foot ATV Trailer with 2015 Toyota Venza
- Article: How to Choose a Bike Rack for a Minivan