Where Are Rear Fascia Tabs Located On Installation of Curt Hitch # C13046 on 2009 Subaru Tribeca
Question:
Where are the bumper fascia tabs? 2009 Subaru Tribeca
asked by: Chris H
0
Expert Reply:
When installing the Curt Class III 2 Inch Hitch, part # C13046, on the 2009 Subaru Tribeca the plastic fascia tabs will be located on the lower part of the bumper towards the corners. It will allow the plastic rear fascia to flex enough to allow the hitch to be installed to the bumper beam. I am including a link to the installation instructions on the Curt hitch, but it does not show where the tabs are located.
expert reply by:
Jeff D
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Hitch Adapters and Extenders
- Article: Best Hitches for Travel Trailers (2022) - For a Smooth, Sway-Free Ride
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Replacement Motor and Gear Box for Landing Gear # ADTH 1RV-200 on Keystone Everest
- Q&A: Compatibility of Curt Multipurpose Ball Mount with Hitch Height Adapter
- Q&A: Is There a Ball Larger Than 2 Inch Diameter For Class II Trailer Hitch
- Q&A: Trailer Hitch Installation for a 2007 Subaru Tribeca
- Q&A: Does the # C13046 Hitch Install Require Modification of the Rear Bumper on a 2006 Subaru B9 Tribeca
- Q&A: Towing Capacity of 2000 Honda Accord V6 Automatic Transmission
- Q&A: How to Install a 7-Way and Brake Controller on a 2009 Subaru Tribeca
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: 2005-Current Volkswagen Touareg, Audi, or Porsche Cayenne
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop