Is Firestone Ride Rite Air Bag Kit F2597 Compatible with 2016 Ford F-250 with B and W Gooseneck
Question:
I don’t have the gooseneck, I have the custom rail kit by b&w. Will I have to drill a hole in the passenger side frame bracket for it to mount to my frame?
asked by: Rob
Expert Reply:
Yes, the Firestone air bag kit part # F2597 that you referenced is compatible with in-bed hitches like the B and W Turnoverball gooseneck # BWGNRK1111 that you have installed in the bed of your 2016 Ford F-250.
For a compressor kit the heavy duty part # F2097 will make inflating the bags and maintaining them very easy. The compressor will inflate faster than standard compressors and the gauge inside the vehicle will allow you to monitor and inflate them from inside the vehicle as well.
Products Referenced in This Question
B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs
- Gooseneck Hitch
- Below the Bed
- Manual Ball Removal
- 7500 lbs TW
- 30000 lbs GTW
- Removable Ball - Stores in Hitch
- Wheel Well Release
- 2-5/16 Hitch Ball
- B and W
more information >
Firestone Air Command Heavy Duty Air Compressor - Analog - Single Path
- Air Suspension Compressor Kit
- Wired Control
- Single Path
- Analog Display
- 150 psi
- Firestone
more information >
Product Page this Question was Asked From
Firestone Ride-Rite Air Helper Springs - Double Convoluted - Rear Axle
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Air Springs
- Heavy Duty
- Firestone
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Brake Controller Installation on 2016 Mercedes-Benz Sprinter
- Q&A: Replacement Connector for a Pollak PA66-MD40
- Q&A: Trailer Wiring Harness Recommendation for a 1999 Isuzu NPR
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Best Air Bag Suspension (2023)
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Components of Firestone Air Suspension Systems
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: How to Wire Two 6-Volt Batteries In Series to Double Output Voltage
- Q&A: Should I Get Loadlifter 5000 Or 7500 For Towing A 15K Fifth Wheel
- Q&A: Air Bag Kit Recommendation for a 2015 Ford F-250 Super Duty for 5th Wheel Towing
- Article: Stability Control for Heavy Duty Vehicles
Rob
3/25/2020
I don’t have the gooseneck, I have the custom rail kit by b&w. Will I have to drill a hole in the passenger side frame bracket for it to mount to my frame?