Best Kayak Trailer for 4 Kayaks

Question

Question:

I have one kayak thats 156inch and the 3 more under 13. What trailer would you recommend? Would the Malone xtralight work or do I need the Microsoft?

asked by: Ian B

0

Expert Reply:

I recommend using the Malone EcoLight Sport Trailer with Post Style Carrier for 4 Kayaks # MAL63FR because it allows you to carry all 4 kayaks where the MicroSport Trailer # MPG461GU is setup for 2 kayaks. The XtraLight trailer has a 275-lbs total capacity, so as long as your kayaks don't weigh more than that combined it would be a good choice to carry all your boats. The XtraLight is designed for use with a 2" hitch ball and comes with a 4 way trailer connector.

If you need the added weight capacity for all 4 boats, the MicroSport will be the better solution, but you will need to remove the integrated Malone SaddleUp Pro Kayak Carrier w/ Tie-Downs # MPG110MD and secure the boats directly to the crossbars. You could also use the Thule Stacker # TH830 to keep your boats separated and stand them up on their sides. The Stacker comes with 1 Pair of ratcheting tie downs, 2 straps, and buckle protectors included to allow you to secure the boats to the trailer.

If you don't already have a ball mount and hitch ball, the Curt # C45036 comes with a ball mount and 2" hitch ball to give you everything you need to tow a trailer.

expert reply by: Erik B

0

Answer 1

I recommend going with the Yakima Rack and Roll Trailer #Y08106 over the Malone #MAL63FR with the Thule The Stacker #TH830. This will give you the ability to carry 3 kayaks on their side rather than side by side. The reason I recommend going with…

view full answer...

Answer 2

You are correct, the trailer hitch is rated higher than the 2013 Honda CR-V but you still have to go by the weight capacities of the vehicle since they are lower. So you will want to stay within the manufacturers 1500 pound limit, even though the…

view full answer...

Answer 3

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 6

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 12

The squeaking noise on your trailer is probably coming from the joints in the suspension creating metal to metal friction. So, unless your original Equa-Flex Cusioned Equalizers are damaged or corroded, what will make the biggest difference is to…

view full answer...

Best Kayak Trailer for 4 Kayaks

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching