How to Perform Regulator Reset Procedure on Roadmaster Even Brake System
Question:
Hi...Found that our even brake wouldn’t hold air and now the compressor isn’t running at all...just worked the past 2 days without problem???
asked by: Randy B
Expert Reply:
It sounds like you'll want to perform a regulator reset to try to get this back up and running again.
1. Remove 1/4 inch airline from backside of invisibrake.
2. Pull break away pin.
3. Turn regulator knob to the left until it stops spinning.
4. Turn regulator knob to the right until it stops.
5. Turn all the way to the left again until it stops spinning.
6. Turn two full turns to the right to see if we get 10psi
(If no 10psi give one more full turn to the right. If yes, proceed to step 7.)
(If no, call Roadmaster.)
7. Set psi to desired setting plus or minus 5 according to your GVWR.
8. Return break away pin to break away box.
9. Return 1/4 inch airline.
10. Wait a few minutes. Then pull break away pin again.
11. Check that the brake pedal is being pulled.
12. Check that the psi is at the setting you left it at.
13. If both step 11. & 12. are good then your regulator is now reset and you may return the break away pin to its housing and return to your travels.
Product Page this Question was Asked From
Roadmaster Even Brake Portable Flat Tow Brake System - Proportional
- Tow Bar Braking Systems
- Brake Systems
- Proportional System
- Recurring Set-Up
- Portable System
- Not Power Assist Brake Compatible
- Air Brakes
- Air Over Hydraulic Brakes
- Hydraulic Brakes
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: Vehicle Tow Bar Brake System
- Shop: Vehicle Tow Bar Wiring
- Shop: Blue Ox Adjustable Drop Hitch Receiver Adapter - 2" Hitches - 4" Rise/Drop - 10,000 lbs
- Shop: T-One Vehicle Wiring Harness with Upgraded Circuit Protected ModuLite HD Module - 4-Way Flat
- Shop: Progressive Dynamics 2000 Watt Inverter w/ Transfer Switch
- Shop: Cam-Action Lockable Door Latch w/ 36" Pipe for Enclosed Trailers - Zinc Plated Steel
- Search Results: cam lock
- Shop: Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Progressive Dynamics REL 90A 4500 Series Inteli-Power Converter Section
- Search Results: propane tank
- Search Results: weight distribution hitch
- Search Results: diode kit
- Search Results: tow diodes
- Search Results: rm~9420
- Q&A: Cannot Adjust Brake Pressure on Roadmaster InvisiBrake Supplemental Braking System
- Shop: Base Plate for Tow Bar
- Search Results: roadmaster
- Q&A: Troubleshooting Roadmaster Invisibrake that Shows Zero Pressure
- Q&A: Why Isn't Roadmaster InvisiBrake Supplemental Braking System Good For Mountainous Areas
- Video: Roadmaster InvisiBrake Supplemental Braking System Installation - 2019 Jeep Cherokee
- Q&A: Determining Braking Pressure on Roadmaster InvisiBrake Supplemental Braking System # RM-8700
- Shop: Vehicle Sway Bars
- Q&A: What Is The Needed PSI For Roadmaster InvisiBrake Supplemental Braking System & Jeep Wrangler
- Video: Roadmaster InvisiBrake Braking System Installation - 2014 Jeep Wrangler
- Video: Roadmaster InvisiBrake Supplemental Braking System Installation - 2018 Jeep JK Wrangler Unlimited
- Video: Review of Roadmaster Tow Bar Braking Systems - Replacement Exhaust Valve - RM-450601-50
- Video: Best 2018 Jeep Jk Wrangler Base Plate Options