How to Remove the Rear Bumper to Install Curt Hitch # C11744 on 1999 Mercedes-Benz E320 Sedan
Question:
Hi, I need to install this in 1999 Mercedes E320 Sedan but it required removal of rear bumper. Do you have instruction on how can I remove my rear bumper? Thanks
asked by: Talha
Expert Reply:
The steps to remove your rear bumper are detailed in step two of the installation instructions that I have attached for you.
First, you will temporarily remove plastic panel on inside edge of tire well by removing two screws and pulling out retaining clips. Under this panel there are three bumper retaining nuts recessed in the rear panel. Note: mounted to the inside surface of the bumper fascia are cellular telephone antennas on both left and right sides.
Next, carefully slide antennas out of mounting brackets and remove wires from bumper assembly and temporarily place antennas in trunk.
Then remove the nuts attaching the bumper and carefully slide bumper assembly rearward, removing antennas as noted above.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- No Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Shop: Trailer Wiring
- Q&A: Trailer Hitch and Wiring for a 2000 Mercedes E320 Sedan
- Shop: Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 7-1/4" Long - 3,500 lbs
- Search Results: roof rack
- Shop: Roof Rack
- Shop: Curt Roof Rack for Raised Side Rails - Aluminum - Black - 53-3/8" Long
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Article: How to Choose the Right Trailer Hitch Class
- Video: Choosing the Right Trailer Wiring
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: 44649
- Video: Choosing the Right Brake Controller
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 68149
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Search Results: 25580
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Shop: Brake Controller
- Shop: Grease Seals 10-36 (pair)
- Article: Trailer Wiring Diagrams
- Search Results: dust cap
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Video: etrailer Class III Trailer Hitch Installation - 2016 Jeep Cherokee
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Shop: Fifth Wheel Hitch