Which Torklift Camper Tie Downs Fit 2019 Ram 3500 That Has OEM Electric Side Steps

Question

Question:

Hi there. Just wondering if the TLR3510 can still be installed on a Ram 3500 with the OEM deployable bed step without having to completely remove the step. For example, install the tie down bracket only on the superhitch, still be able to use the bed step, then slide in the tie down attachment and just not be able to use the bed step? Or does the step get in the way when even tying to slide in the tie down? Thx.

asked by: Darren B

0

Expert Reply:

We have a set of Torklift Camper Tie Downs that fit your exact configuration of 2019 Ram 3500 long be with factory electric steps and factory hitch with the part numbers # TLD2140 for the front and # TLD3112 for the rear but the # TLR3510 is only the correct rear fit for if you had a Torklift hitch installed. If you had the Torklift hitch though this would fit and would still allow the step to function like normal without requiring you to remove it.

expert reply by: Jameson C

0

Answer 1

If you install the Torklift Superhitch Magnum part #TLD1111-30 on your 2019 Ram 3500 that currently has the rear tie down part #TLD3112 and a factory hitch you would need to replace the tie down with the part #TLR3510 according to Torklift. So yes…

view full answer...

Answer 2

You will need to remove the factory trailer hitch from your 2019 Ram 3500 to install the TorkLift SuperHitch Magnum Trailer Hitch Receiver #TLD1111-30. I have attached a cutout of what the SuperHitch Magnum looks like assembled for you to get an…

view full answer...

Answer 3

The proper extension for your setup would be the one that allows you to have clearance of your hitch mounted accessory and also allows you to still be able to pull the steps down. If the receiver tube sticks out past the camper too far then you will…

view full answer...

Answer 4

For your 2022 Ram 3500 8 foot bed with a step that extends from the cab under the truck bed, I recommend the HappiJac Truck-Mounted Camper Tie-Downs, #LC236326-205221. The HappiJac Direct-to-Frame design ensures proper distribution of your…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 7

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 8

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 9

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 10

Normal operating temperatures for drum brakes range from 150-400 degrees F. During certain stopping conditions the brake heat can exceed 600 degrees. The effectiveness and stopping power of the brakes is significantly reduced at these higher…

view full answer...

Answer 11

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 12

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Which Torklift Camper Tie Downs Fit 2019 Ram 3500 That Has OEM Electric Side Steps

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching