Can the 7-Way Plug On the Electric Jack w/ Footplate EJ-3527-BBX Be Removed

Question

Question:

trailer jack comes with a 7 way plug can you take the plug off and wire it up to a battery without any problems

asked by: Russell B

1

Helpful Expert Reply:

The Electric Jack w/ Footplate is offered both with the plug part # EJ-3527-BBX and without the plug part # EJ-3520-BBX. Therefore, if you wanted to go with the model that has the plug and just cut that off you would indeed just run the wire to the battery or you can go with the model that has the blunt cut wire which is more cost effective.

expert reply by: Conner L

1

Answer 1

The Electric Jack #EJ-3527-BBX, and other jacks that operate from power supplied from the 7-way plug, rely on the ground and 12VDC contacts to deliver operating power requirements. Those contacts are located, respectively, at the 5:00 and 11:00…

view full answer...

Answer 2

Yes. A 3,000 pound electric jack will work just fine. Based on your trailer weighing 7,500 pounds loaded will equate to your tongue weight between 750-1125 pounds. Although you can choose a 2,500 pound (see link attached) electric jack, I would…

view full answer...

Answer 3

The Ultra-Fab Protective Cover for Electric A-Frame Jacks - Vinyl - 12" x 14-1/2" #UF38-944020 is the protective cover I recommend for your DISCONTINUED Husky Brute Trailer Jack HT87247. I've attached a photo of the dimensions when laid…

view full answer...

Answer 4

The Electric Jack w/ Footplate and 7-Way Plug #EJ-3527-BBX uses a 7-way RV-style plug. I have included a diagram that shows the pin-out for RV style 7-way plugs. This will show you what each pin does. I have also listed the functions below and linked…

view full answer...

Answer 5

For a 3500 lb Electric Jack, I recommend the Bulldog Powered-Drive Trailer Jack - Drop Leg - A-Frame - 14" Lift - 3,500 lbs - Black #BD500187. This jack uses a 12 volt system, so it is compatible with your 7-way although a battery is always a…

view full answer...

Answer 6

The etrailer brand #EJ-3527-BBX is equipped with a 7-way plug that technically can be plugged into the 7-way trailer connector on your 2020 Ford F-150, but it will not function due to the "intelligent" towing package these come with now.…

view full answer...

Answer 7

The Electric Jack w/ Footplate and 7-Way Plug #EJ-3527-BBX that you referenced has a height of 20-1/2 inches from where it mounts to your trailer frame to the top of the jack.

view full answer...

Answer 8

The Electric Jack w/ Footplate and 7-Way Plug #EJ-3527-BBX uses the standard 3 inch A-frame jack mounting pattern. The holes are slightly slotted too which means yours measuring 3-1/4 inch would fit just fine.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 11

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 12

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Can the 7-Way Plug On the Electric Jack w/ Footplate EJ-3527-BBX Be Removed

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching