On Board Converter To Use with AGM Batteries
Question:
I have a Inteli-Power PD9100 Converter which is used to charge my batteries as well as supply coach accessories. I am using AGM batteries and this charger isnt powerful enough to supply the 14.7 absorption needed for bulk phase charge. Is there a inverter designed for AGM batteries?
asked by: Steve E
Expert Reply:
I recommend looking at the Go Power RV Converter and Smart Battery Charger # 34266912 which has a maximum output of 14.4v and is designed to work with AGM batteries. This is the most powerful converter and smart battery charger we have and it is rated much higher than the 13.6v max on the Progressive Dynamics 9100 series converters like the # PD9130.
Per the instructions (included) you will need to remove your existing converter, as it is not designed to work on conjunction with that system.
Products Referenced in This Question
Go Power RV Converter and Smart Battery Charger - 12V - 100 Amp
- RV Converters
- Smart Charge
- 12V
- 100 Amps
- Lead Acid
- Go Power
more information >
Product Page this Question was Asked From
Progressive Dynamics PD9200 Series Battery Converter Charger with Charge Wizard - 12 Volts - 60 Amps
- RV Converters
- Smart Charge
- 12V
- 60 Amps
- Lead Acid
- Progressive Dynamics
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Go Power RV Converter and Smart Battery Charger - 12V - 100 Amp
- Shop: Brake Controller
- Shop: Advent Air Low Profile RV Air Conditioner - 13,500 Btu - White
- Shop: Trailer Wiring
- Shop: Progressive Dynamics 4100 Series RV Converter w/ Charge Wizard and AC/DC Distribution Panel - 35 Amp
- Shop: Curt Echo Wireless Brake Controller - 7-Way Plug Mount w/ Bluetooth App - 1 to 2 Axle - Proportional
- Shop: Trailer Hitch
- Shop: Rambler ST175/80R13 Radial Trailer Tire - Load Range C
- Shop: Towing Mirrors
- Search Results: advent
- Shop: Dometic Weekender RV Toilet - Low Profile - Round Bowl - White Polypropylene
- Search Results: advent ac
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Video: Go Power RV Converter and Smart Battery Charger Installation - 2002 Coachmen Cross Country Motorhome
- Search Results: c51180
- Search Results: pl~3
- Search Results: 179327
- Shop: Performance Chip Tuners
- Shop: Vehicle Sway Bars
- Shop: Fluid Filters
- Q&A: Will 100 Amp Go Power RV Converter and Smart Battery Charger Work For 200ah AGM Battery Bank
- Search Results: trailer brakes
- Search Results: trailer backup lights led
- Video: K-Source Universal Dual Lens Towing Mirrors Installation - 2020 Chevrolet Tahoe
- Video: Review of Maxxair RV Vents and Fans - Enclosed Trailer Parts - MA10A21275K
- Video: Gustafson Lighting RV Lighting - Porch Light - 277-000484 Review
- Q&A: How to Connect two 12 Volt Batteries and Still have 12 Volts Output
- Video: MORryde Locking RV Storage Box Manufacturer Demo
- Video: Review of MORryde RV Cargo Carrier - Locking RV Storage Box - MR43RR
- Q&A: Upgrading Power Converter/Battery Charger When Switching to 6 Volt Coach Batteries
Peter G.
7/15/2020
I have a 2007 Holiday Rambler travel trailer. the original converter was designed for marine batteries, I installed two six volt AGM batteries. The original converter is a TP3 SS Atwood 55 amp unit. It is not appropriate for newer AGM type batteries as it overcharges them. Will this 12V - 60 amp unit work well for me in order to solve that issue? The trailer usually uses 30 amp service, not 50. There are four wires that are used to install the original. How does this new unit install with a standard three prong plug? Is there tech service I could contact if I have install questions? Thank you.