Will the JR Products RV Floor Registers Fit a 4 Inch x 9-3/4 Inch Cutout
Question:
I have 2019 Cedar Creek with 5 floor heater vents undamped brown but are plastic and I would like to replace with metal. All the sites Ive looked at the opening size is 4inch x 10inch - the openings in the floor in this RV are 4inch x 9-3/4. and the plastic that goes in the opening is the same. Do you have anything that will fit? Thanks.
asked by: Eric P
Helpful Expert Reply:
The JR Products Undampered RV Floor Register part # 37202-28995 should fit just fine though you might need to shave a bit off each side of the opening. That said, the required cutout is actually slightly smaller than 10" and I am pretty sure this is the size you need. The next smallest size down is the JR Products Undampered RV Floor Register part # 37202-28955 which is 4" x 8".
Products Referenced in This Question
RV Floor Vent - 4" x 8" - Steel - Brown
- RV Vents and Fans
- Vent
- Floor Vent
- No Fan
- 4W x 8L Inch
- Metal
- Brown
- JR Products
more information >
Product Page this Question was Asked From
RV Floor Vent - 4" x 10" - Steel - Brown
- RV Vents and Fans
- Vent
- Floor Vent
- No Fan
- 4W x 10L Inch
- Metal
- Brown
- JR Products
more information >
Continue Researching
- Video: JR Products Dampered RV Floor Register Review
- Search Results: floor register
- Q&A: Floor Vent Register Recommendations for a Replacement 5" x 10" Vent
- Shop: RV Floor Vent - 4" x 8" - Steel - Brown
- Shop: RV Floor Vent - 4" x 10" - Steel - Brown
- Shop: RV Floor Vent with Damper - 4" x 10" - Steel - Brown
- Shop: RV Floor Vent with Damper - 4" x 8" - Steel - Brown
- Shop: Trailer Hitch
- Search Results: 44649
- Video: Choosing the Right Trailer Wiring
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Shop: MaxxAir MaxxFan Mini Roof Vent w/ 12V Fan - Manual Lift - 4 Speed - Black
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wiring
- Search Results: 68149
- Q&A: How Do I Measure the Drop Distance on a Trailer Drop Axle?
- Search Results: dust cap
- Video: Review of Curt Custom Fit Vehicle Wiring - Fifth Wheel and Gooseneck Wiring - C56070
- Q&A: Solution for Squeaky/Noisy Trailer Suspension with Equa-Flex Equalizers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Shop: Fifth Wheel Hitch
- Search Results: 25580
- Video: etrailer Class III Trailer Hitch Installation - 2024 Subaru Crosstrek
- Shop: Brake Controller
- Q&A: Picking Out Replacement Axle for Snowbear 550LHD Trailer
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Replacement Hub for 2013 Wildwood 26TBSS Hub Drum with AL-KO 8700