How To Extend Handle On Bristol Waste Valve for RV Gray Water Tank

Question

Question:

is there a rod extension that can be purchased with this product

asked by: Mike

1

Helpful Expert Reply:

Yes, the Extension Rod for LaSalle Bristol Waste Valve part # 34466SP1106 or part # 34466SP1112 can be added to the Bristol Waste Valve for RV Gray Water Tank part # 34466N11AB to extend the handle. If you need more than the above then you can just thread multiple onto one another to obtain the length you need. The handle will thread off, the extension will thread on, and the handle then threads back onto the extension.

expert reply by: Conner L

1

Answer 1

Yes, the Black Handle #34466IHANDLE and Gray Handle #34466IHANDLEGRY will unscrew from the Bristol Double RV Waste Valves #34466ND14AAR. This will allow you to add the extension you need to make the handles easier to reach. 6" Extension…

view full answer...

Answer 2

For your electric jack, there are only three possible explanations for your jack not working with a charged battery. Either power is not getting to your motor, your motor is bad, or your ground connection isn't working properly. To test power,…

view full answer...

Answer 3

The Bristol Double RV Waste Valves #34466ND14AAR is about 9" long outside to outside. Attached is a photo showing this as well as a review video you can check out.

view full answer...

Answer 4

Yes you could remove the center section of the valve part #34466N11AB and install it in place of what you may have on your Forest River Cardinal. In general these are all made to the same standard dimensions but you'd need to verify that what you…

view full answer...

Answer 5

Yes we've confirmed with both Valterra and LaSalle Bristol that the threads of both of the extension rods are the same 1/4 inch size. So the #34466SP1112 that you referenced which is 12 inches long would work well for you.

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 8

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 9

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 10

National seal 472920 has an inner diameter of 2.25 inches and outer diameter of 3.375. For a replacement, you will want Grease Seal - Double Lip #GS-2250DL or oil seal #10-63.

view full answer...

Answer 11

Thanks for the picture of what you have and the info you listed. The correct wheel you need is the part #AM20794 that you referenced.

view full answer...

Answer 12

From what I could find, the #171255UC grease seal has an inner diameter of 1.719 inches and an outer diameter of 2.565 inches. These dimensions match our TruRyde Double Lip Grease Seals, #RG06-050. If possible, I recommend verifying the inner…

view full answer...

How To Extend Handle On Bristol Waste Valve for RV Gray Water Tank

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching