Delay In Braking After Filling Brake Fluid Reservoir On Dexter Brake Actuator
Question:
Why is it a delay with my brakes after I put brake fluid in the pump
asked by: Cedric C
Helpful Expert Reply:
If the Dexter Brake Actuator is new and you are adding brake fluid for the first time or you are adding new brake fluid (not topping it off) then you will need to bleed the brakes because you most likely have a air bubble in the lines which is delaying your braking. Some of the Dexter actuators have a self priming pump which makes the process easier but I am not sure of which model you have. I have attached a link on bleeding the brakes.
You may also have a damaged brake line, it is a good idea to check all of the brake lines for damage if bleeding the brakes does not do the trick.
Product Page this Question was Asked From
Dexter DX Series Electric Over Hydraulic Brake Actuator for Disc Brakes - 1,600 psi
- Brake Actuator
- Electric-Hydraulic Brake Actuator
- 1600 psi
- Disc Brakes
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Replacement Trailer Grease Seals for Allis 5013 29772
- Q&A: Replacement Hub for 2013 Wildwood 26TBSS Hub Drum with AL-KO 8700
- Q&A: Replacement For Fulton Drop-Leg Stabilizer Jack
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Where to Position the Trailer Axle?
- Article: Flat Towing Package for 2008-2011 Honda CR-V
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size