Edge Evolution Programmer OBDll Code P2004 and P2006
Question:
I had the edge programmer in my truck, got the intake code for it being stuck closed, fixed the intake and then after a few days the codes for it being stuck closed and open came up. No difference driving. I do also have a cold air take as well. Is this just the programmer throwing false codes?
asked by: Adam R
Expert Reply:
The P2004 manifold runner control stuck open and P2006 manifold runner control stuck closed OBDII code is being read directly from the engines PCM, so it's not being caused by the programmer.
It's recommended that you check the intake runner control module actuator or for a restricted vacuum line. This could also be indicative of failure of the PCM itself.
Product Page this Question was Asked From
Edge Gas Evolution CTS3 Performance Tuner - Color Screen
- Performance Chip
- Performance Tuners
- With Monitor
- Color Touch Screen
- No - Not California Approved
- Evolution
- Edge
more information >
Continue Researching
- Q&A: Recommended Tuner for 2018 Ford F-150 with 5.0L Engine
- Q&A: How to Determine if Dexter Tandem-Axle Trailer Hanger Kit for 2-1/2 Slipper Springs Will Work
- Article: Performance Chips and Modules
- Article: Gooseneck Trailer Hitch Information and Review
- Q&A: What Is The Angle For The etrailer A-Frame Trailer Coupler?
- Q&A: Why Would Right Turn Signal Come on When Left Turn Signal is On for Trailer Wiring
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: 7-Way Connector Recommendation For 2010 Ford Flex To Use With Brake Controller
- Article: Best Air Bag Suspension (2023)
- Q&A: Can an Edge Programmer be Reset if it is Installed on a Vehicle
- Article: Stability Control for Heavy Duty Vehicles
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams