What is Needed to Install LED Clearance Lights on a 2006 Toyota Tundra with a Flatbed
Question:
i am putting an aluminum flatbed on my 2006 tundra doublecab w/ tow package. what kind of wiring harness can i use that will plug into factory pigtail for 4inch round led stop/turn/tail lights? also, what are your best led lights for this application? could possibly wire into trailer light socket? thanks for your help,
asked by: Bill
Expert Reply:
While we do not sell an aftermarket pigtail that would allow you to simply plug into your current tail light assembly you could use a circuit tester to identify the circuits of your tail light assembly and then wire the Optronics Clearance Light # STL23CCRB to the correct circuits. For a circuit tester you could use our part # PTW2993.
The harness you would need with this light would be the Pigtail Harness # A47PB. From that harness you would run the white wire to ground, red to turn signal/brake and black to tail light.
Since the bulbs on your truck are incandescent and you will be going to an LED light you will need to install a Putco LED Load Resistor # P230004A on each bulb to prevent hyperflashing. I attached installation instructions for this product for you to check out also.
Products Referenced in This Question
Right Angle 3-Wire Pigtail for Optronics Trailer Lights - 3-Prong PL-3 Plug - 10" Lead
- Accessories and Parts
- Trailer Lights
- Wiring
- Plugs and Pigtails
- 10 Inch Long
- Three Wire
- Right Angle Pigtail
- Optronics
more information >
Product Page this Question was Asked From
Miro-Flex LED Trailer Tail Light - Stop/Turn/Tail - Submersible - 12 Diodes - Round - Clear Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4-5/16 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Shop: RV Exterior Lighting
- Shop: GloLight Uni-Lite LED Clearance or Side Marker Light with Grommet - Turn - Round - Amber Lens
- Shop: LED Trailer Dome Light for Remote Switch - Surface Mount - 2,200 Lumens - White Base - Clear Lens
- Shop: Replacement Female Pipe for etrailer and Ram Pipe Mount Swivel Jacks - 5/8" Pin Hole
- Shop: Butt Hinge w/ Non-Removable Pin - 2-1/2" x 2-1/2" - 3/16" Pin - Stainless Steel
- Q&A: Wiring Diagram for Installing Junction Box Upgrade to Utility Wiring Colors
- Q&A: What Size Hole Is Needed For Mounting Optronics Trailer Light, # MC57AB, In A Rubber Grommet
- Search Results: trailer light
- Search Results: micro~flex
- Search Results: miro~flex
- Search Results: a49pb
- Search Results: compression latch
- Search Results: mc57ab
- Search Results: backup lights
- Video: Command Electronics Trailer Lights - Clearance Lights - 328-003-183RR Review
- Video: Optronics Trailer Lights - Utility Lights - UCL90CB Review
- Video: Optronics RV Lighting - Utility Light - ILL08COB Review
- Video: Optronics Trailer Lights - Clearance Lights - MCL63RB Review
- Video: Optronics Round LED Trailer Side Marker and Clearance Light Installation
- Video: Optronics Trailer Lights - Clearance Lights - MCL121AK9PVG Review
- Video: Optronics Flexible LED Light Strip Review
- Shop: LED Trailer Dome Light with Switch - Surface Mount - 2,200 Lumens - White Base - Clear Lens
- Shop: Miro-Flex LED Combination Trailer Tail Light - 8 Function - Submersible - 18 Diodes - Driver Side
- Shop: LED Clearance and Side Marker Light w/ Locking Ring - Submersible - 1 Diode - Round - Red
- Q&A: Replacement Taillights for Little Guy 4-Wide Tear Trailer
- Q&A: Recommended Suspension and Sway Improvements for 2002 Winnebago Adventurer
- Q&A: Current Available to RV When Using Power Grip RV Power Cord Adapter CAM55185
- Q&A: Connector Types on Camco Power Grip RV Power Cord Adapter CAM55185
- Q&A: Are all Pins of the Power Grip RV Power Cord Adapter # CAM55185 Active
- Article: Trailer Wiring Diagrams
on Trailer Lights
