Brake Controller Recommendation to Replace Factory Controller of 2005 Ford F-250

Question

Question:

My 2005 Ford F-250 Truck Factory Tow Haul Brake Controller 7 Pin has a short and wanting to change to after market Brake Controller. Pls quote and recommend controller and Wiring harness with installation instructions. Thanks

asked by: Ray S

0

Expert Reply:

For a brake controller to replace the integrated controller of your 2005 Ford F-250 I recommend the Prodigy P3 Brake Controller part # 90195. This is one of our best selling brake controller because of how well it works and how easy it is to setup. This is a proportional brake controller that senses the amount of braking the tow vehicle is applying and applies a proportionate amount to the trailer brakes. This will be the last brake controller you buy as it is incredibly reliable, works, well and is easy to use. It can easily be transferred to future vehicles as well.

To install the controller you'll need to unplug the factory one from the port under your dash and then plug in the P3 with the install harness part # 3065-P that you referenced.

Once the OE controller is unplugged and the aftermarket unit is installed, there will probably be an error code shown on the message center on the dash. Your Ford dealer can remove the code very easily.

expert reply by: Jameson C

0

Answer 1

In the video you're referring to of the 2015 Ram 3500 we installed the Prodigy P3, part #90195, simply because the customer wanted one. He wasn't happy with the performance of the factory integrated brake controller on his truck and he had…

view full answer...

Answer 2

The Tekonsha Prodigy P3 Trailer Brake Controller #90195 goes into a sleep/power saving mode after it doesn't detect any movement for 15 minutes (and the vehicle is turned off). If you are concerned that the unit is staying fully powered beyond…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

I recommend installing the Firestone Ride-Rite Air Helper Springs #F2597 on your 2015 Ford F-250 Super Duty. This has a 5,000 lb weight capacity (although it only helps handle the load and won't increase the truck's weight capacity) and is…

view full answer...

Answer 5

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

By all accounts the Curt Spectrum Trailer Brake Controller #C51170 works well and is easy to use and install on most vehicles. It is a brand new item so not a lot of feedback has come in on it. I did learn a few things though after speaking with our…

view full answer...

Answer 8

You are correct that the Jeep bracket should have been reinstalled when installing the Blue Ox Base Plate #BX1139. I have linked another video near the bottom of the page where you can see the brackets being reinstalled on a 2020 Jeep Wrangler around…

view full answer...