How To Find the Correct Dust/Grease Cap for a Trailer Axle
Question:
i am looking for grease caps . my spindles have an ID of 2.240 pls advise
asked by: Rheerents
Expert Reply:
In order to find the correct grease cap for a trailer you will need to either measure the inner diameter of the hub bore on your trailer hub or the outer diameter of your grease cap but these are the only two ways. The measurements will need to be taken with a digital caliper which it sounds like you already have one. If you can provide me with either of the above two measurements then I would be glad to see if we have an option for you or you can browse our selection I have attached below.
I am not quite sure where you were measuring so I would not be able to confirm the correct grease cap based on this alone.
Product Page this Question was Asked From
Grease Cap, 1.988" OD Drive In - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- Standard Grease Cap
- 1.98 Inch O.D.
- TruRyde
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Video: Review of MORryde X-Factor Crossmember Adapter Kit For Correct Track - MR93WR
- Video: MORryde Standard Frame Hanger X-Factor Crossmember Review
- Video: MORryde Standard Frame Hanger X-Factor Crossmember Installation - 2014 Jayco Pinnacle Fifth Wheel
- Shop: Replacement Velcro Strip for Access Tonneau Covers - 1-1/2" x 17'
- Q&A: Replacement Bearings for an AL KO 5,200 lb Axle
- Q&A: How Do You Determine If An Axle Is Rated For 6,000 or 7,000 lb Capacity?
- Q&A: Does Race Need To Be Replaced If Installing New Bearings
- Q&A: Do Hub Races Have to Be Replaced Each Time Bearings Are Changed
- Q&A: Axle Capacity with Bearings 28580 and 25580 with Seal SKF23839
- Shop: Replacement Trailer Hub Bearing - LM67048
- Shop: MORryde X-Factor Crossmember for Standard Frame Hangers
- Shop: MORryde X-Factor Crossmember Adapter Kit for Correct Track Hangers
- Shop: MORryde X-Factor Crossmember for LRE, RE, or TRE Leaf Spring Suspension
- Shop: Replacement Trailer Hub Bearing - 25580
- Q&A: How to Measure a Trailer Hub or Dust Cap to Find the Right Replacement Dust Cap
- Shop: Grease Cap, 1.988" OD Drive In - Qty 2
- Q&A: How to Measure a Trailer Hub for the Correct Size Grease Cap
- Search Results: dust cap
- Video: TruRyde E-Z Lube Grease Caps Plug Review
- Video: Redline Dust Cap Driver Tool Review
- Search Results: axle dust cap
- Video: TruRyde Trailer Bearings Races Seals Caps - Caps - RG04-040 Review
- Search Results: dust caps
- Search Results: dust cap tool
- Search Results: dexter ez lube grease caps
- Search Results: dust cap installation tool
- Search Results: hub dust caps