Is There a Way to Lock Rhino Rack Batwing Awning to Roof

Question

Question:

Hello! Im wondering if the Thule Awning Adapter will work to lock a Rhino Rack Batwing. I currently have Thule Aeroblade bars installed on my car.

asked by: Bree

0

Expert Reply:

Since Rhino Rack doesn't offer a lock designed for the Batwing like the # RR33200 and the Thule you mentioned would not work the best option is a cable lock like the part # e98891 which you could wrap around the awning setup to secure it.

expert reply by: Jameson C

0

Answer 1

If you are getting no signal when testing the running light pin on your 2009 Ford F-250, with a tester like part #PTW2991, then it very well could be a fuse or relay. When I looked up the online owner's manual for your F-250 it looks like you…

view full answer...

Answer 2

Yes, the Rhino-Rack Sunseeker Awning #RR32133 comes with bolts that fit in the T-Slots on Yakima JetStream crossbars so they are compatible with each other. I have attached a review video of this for you to check out as well as the installation…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

Another wire or harness is not needed on the 2023 Honda CR-V for the install of the Curt 4-Way Wiring Harness #C56370, but you do have to add 20 amp fuse to location #17 in the fuse box.

view full answer...

Answer 6

I did some looking and found that the 46210 and 46845 hubs you currently have use the same #L68149 inner bearing and #L44649 outer bearing. However, as we do not carry the Tie Down Engineering Vortex hubs, I cannot say what all will fit them,…

view full answer...

Answer 7

The Dexter 8-427 hub is no longer available. Even looking through Dexter's site the only references to it are replacement bearings. You can use a wheel with a larger pilot hole as long as the wheel attaches to the hub using lug nuts and not…

view full answer...

Answer 8

The 07100 bearing number you referenced is an older bearing that has the same dimensions as #L44643. If both the inner and outer bearings on your existing trailer are the 07100/ #L44643, and the hub has a 4 on 4 inch bolt pattern, the correct…

view full answer...

Is There a Way to Lock Rhino Rack Batwing Awning to Roof

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching