What Size are the Mounting Holes on the Junior Locking Stainless Steel Flush Door Latch
Question:
What size are the screw or rivet mounting holes on the latch
asked by: Eric S
0
Expert Reply:
I spoke with Redneck Trailer Supplies and they informed me that the mounting holes on the Junior Locking Stainless Steel Flush Door Latch part # L1883 are about 3/16" diameter.
expert reply by:
Conner L
0
Product Page this Question was Asked From
"Junior" Locking Stainless Steel Flush Door Latch
- Trailer Door Latch
- Latches
- Flush Latch
- Stainless Steel
- Built In Lock
- 2-3/4 x 3-3/4 Inch Cutout
- Redline
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Which Brakes to Fit in Dexter 8-247 Hub and Drums
- Q&A: Wheel and Tire Recommendation For Jet Ski Trailer with Tire Size ST175/80R13
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Q&A: Replacement Kwikee Step Controller for Part 1800709 on 2017 Thor Windsport
- Q&A: Replacement Clearance Lights Needed for GLO-BRITE 122R and 122Y Lights
- Q&A: How Long Does it Take to Install Roadmaster Base Plate Kit
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Where to Position the Trailer Axle?
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacing Trailer Buddy 32220 Reverse Solenoid on Ranger Boat Trailer
- Article: Car Camping Checklist
- Article: Will Flat Towing Blow Up Your Transmission?