Which TorkLift GlowStep Stow N' Go Scissor Steps Fits 2019 Grand Design 337RLS

Question

Question:

I have a 2019 Grand Design 337RLS . Opening 27.5,stairs 24x8.75.distance bottom of door to ground 35 inches.

asked by: Dennis B

0

Expert Reply:

Since your door entry height is 35 inches the TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear # TLA7844 that you referenced is the correct fit as it has a height range of 31 to 42 inches. The individual steps are a bit smaller than what you have as they are 20 inches wide and 8 inches deep but this would still work great on your 2019 Grand Design 337RLS!

expert reply by: Jameson C

0

Answer 1

I found the answer page that Kyle made about the Curt front hitch #C31078 and found that Kyle did list that this hitch does NOT fit a dually model. Now that said I looked further into why the front hitches don't fit the dually models and…

view full answer...

Answer 2

We do have camper tie-downs other than the Torklift, but there are several restrictions for their use. One of the tie-downs is part #HSSF. These clamp onto the bed rails of your truck. The restrictions are the bed rail cannot exceed 5-1/2 inches…

view full answer...

Answer 3

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 6

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 7

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 8

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 9

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 10

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 11

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 12

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Which TorkLift GlowStep Stow N' Go Scissor Steps Fits 2019 Grand Design 337RLS

Product Page this Question was Asked From

Continue Researching