How Many Urethane Bumpers are Used for Demco 5th Wheel Hitches

Question

Question:

I have a Demco autoslider premier hitch in my truck. It has one of the plastic ,blue bumper pads. Should it have two?

asked by: Larry M

0

Expert Reply:

There should only be 1 Urethane Bumper # DM15469 under the head unit of your Demco 5th wheel hitch. There are 2 bumpers under the yoke that the head sits in though which I think is where the confusion comes in.

I am attaching some photos that my contact at Demco sent me. The 5th wheel hitch in the photo is their Recon hitch but the bumpers apply to all of the Demco 5th wheel hitches.

expert reply by: Jon G

0

click to enlarge

Answer 1

We did have one customer come back and say there was some noise with the Demco Recon part #DM8550045 while towing but most have reported back that it worked well for them without noise mentioned at all. I wouldn't say this has a reputation for…

view full answer...

Answer 2

To me that looks like one of the urethane bumpers #DM15469, so you'll want to replace that first. This was most likely caused by wear and tear as the clunking I believe to be related to your capture plate needing to be adjusted. What you're…

view full answer...

Answer 3

Thank you for purchasing the Demco Hijacker Autoslide 5th Wheel Trailer Hitch #DM8550034 back in 2017. All replacement parts we sell appear on the page I linked for you. I also linked the install instructions for this hitch and on pages 9 through 11…

view full answer...

Answer 4

You ordered the correct urethane dampener for your Demco Hijacker AutoSlide part #DM8550024. The 15769 and the 15469 basically represent the same part number now so the #DM15469 that you ordered will fit and work well!

view full answer...

Answer 5

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 6

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 11

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 12

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

How Many Urethane Bumpers are Used for Demco 5th Wheel Hitches

Product Page this Question was Asked From

Continue Researching