Unable to Locate Connector to Install Brake Controller on 2016 Ram 1500 Express
Question:
Looking to add a brake controller to my truck. I do not seem to have the factory 4 pin connector needed. I have included a photo from your site, I have the plug that is NOT being pointed at and is gray and orange instead of white. The smaller white plug is only 2 wires and is for dual zone climate control I am told.
asked by: Jason
Expert Reply:
Thank you for the photo.
It appears all 2016 Ram 1500 trucks are equipped with a factory installed 7 and 4 pole connector by the rear bumper. If that is the case in your truck then you should have the correct plug to mate to a brake controller. It may just be tied or tucked away behind other wires under your dash, right above your gas pedal.
Once you locate it, you can use # 3024-P to install a brake controller like the very highly rated Tekonsha P3 part # 90195 with customizable LCD display, storable settings, 3 boost levels, battery protection and continuous diagnostics.
Another more convenient option for your particular situation is the Curt Echo # C51180. This is a Bluetooth enabled brake controller which requires zero wires so you can forget about wasting time searching for a brake controller plug.
It simply plugs in to your 7-way and can be controlled directly through your smartphone.
Check out the review video on this unit I have attached for you.
Products Referenced in This Question
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ram
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Curt Echo Wireless Brake Controller - 7-Way Plug Mount w/ Bluetooth App - 1 to 2 Axle - Proportional
- Trailer Brake Controller
- Proportional Controller
- Hidden
- Up to 2 Axles
- Smartphone Display
- CURT
more information >
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ram
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Options For Replacing A Tie Down Turbo Lube 48394 Clear Oil Bath Cap
- Q&A: Can 215-60-8 Trailer Tires be Replaced with 215/65-10 Tires on Snowmobile Trailer
- Q&A: Bearings For Older Trailer Hub 22834
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Master Cylinder And Shock For UFP A-60 / A-75 / XR-84 Surge Brake Actuators
- Q&A: Replacement Power Distribution Panel for Iota IDP-240
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Top Gifts for Dads in 2024
- Q&A: Latch Repair Kit For Bulldog A256 2-5/16" Ball Latch Coupler
- Q&A: Trailer Hitch for 2020 Mercedes GLE 350 4-Matic
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)