Will the Draw-Tite Class I Receiver # 24847 Fit a 2012 Toyota Prius
Question:
I need to verify the drawtite hitch listed for the Prius V. The page talks a lot about the 2011 Prius sedan.
asked by: Monica D
0
Expert Reply:
According to my contacts at Draw-Tite, the Draw-Tite Class I receiver # 24847 is a fit for the 2012 Prius and the Prius V.
I have linked you to the install instructions as well as an install video that you might find helpful. The video shows the hitch being installed on a 2010 Prius, but the procedure for your 2012 Prius V would be very similar.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Hub Recommendation for Dexter Hub 8-250
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Is Bow in 3,500 lb Trailer Axle Enough Camber for Loaded and Unloaded Trailers
- Q&A: How Much Upward Bend Should Trailer Axle Have
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What Should Tire Pressure be for a Load Range G 110 psi Tire
- Article: Where to Position the Trailer Axle?
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Mounting the Aluminum A-Frame Trailer Tongue Toolbox to the A-Frame of The Trailer
- Article: Rooftop Cargo Carriers
- Article: Best Bike Racks for Electric Bikes
- Article: Determining Trailer Tongue Weight
- Article: 5 Things to Know About Weight Distribution Hitches