What Would Cause An Above Floor Slide Out To Constantly Shear The Motor Shaft
Question:
This motor was installed in my above the floor power gear slide out system a year ago in my Okanagan 2007 116ULT truck Camper and it is shearing pins constantly. Is it supposed to have a clutch to keep it from over extending and retracting? Also, this slide only has 2 rails that extend under the slide. The original manufacturer was Happi Jac and power gear according to my original documentation, but I have no manuals for either, just instructions, and no part numbers for the originals to compare this with. Is this motor too strong for my slide and that is why it is shearing the pins on me? 138449 motor pn HELP? Thanks folks.
asked by: Rayne
Expert Reply:
I am not sure which exact slide-out system you have as there are several, made by both Power Gear and Happijac but I spoke with Lippert who now owns Power Gear. They informed me that there is not a clutch to stop the motor from overextending nor do they think the motor is overpowered but what they suspect is happening is that the slide is dragging which is then not allowing the drive shaft to turn thereby shearing the pin. In order to confirm this you would need to look under the trailer while the slide is retracting/extending to see if anything is catching.
If you need a new motor/gear box, the Lippert Components D-300 RV Slide-Out Motor By Klauber part # LC138449 matches what you have now. If you don't find anything dragging you really ought to just take the trailer in for service as there is not much else that can be done without seeing the trailer firsthand.
Product Page this Question was Asked From
Lippert D-300 RV Slide-Out Motor By Klauber - 3/4" Drive
- RV Slide Out Parts
- Motor Parts
- Motor
- Lippert Through-Frame Slide-Out Systems
- Lippert
more information >
Continue Researching
- Shop: Valterra RV Ceiling Vent w/ Dampers and Covered Screws - 5" Diameter - White
- Shop: Dexter Trailer Axle w/ Electric Brakes - E-Z Lube - 6 on 5-1/2 Bolt Pattern - 86-1/2" - 5.2K
- Shop: Valterra RV Ceiling Vent w/ Dampers and Covered Screws - 5" Diameter - Light Beige
- Shop: Replacement Rod and Nut for etrailer and Ram Square, Direct Weld Jacks - 12K
- Shop: Dexter Trailer Axle Beam with E-Z Lube Spindles - 86-1/2" Long - 5,200 lbs
- Shop: Valterra RV Ceiling Vent w/ Covered Screws - Rotating - 4" Diameter - White
- Search Results: happijac
- Q&A: Steps For Replacing Bevel Gears In HappiJac Jacks
- Search Results: a10~3358vp
- Search Results: a10~3359vp
- Q&A: Troubleshooting EverChill 324-000119 12-Volt Refrigerator WD-282FWDC Not Cooling
- Q&A: Everchill RV Refrigerator Compressor Not Staying On For More Than Two Days
- Shop: RV Interior Lighting
- Q&A: Everchill Model WD-282FWDC-B-6 RC refrigerator
- Shop: Valterra RV Ceiling Vent w/ Dampers and Covered Screws - 5" Diameter - Medium White
- Search Results: compartment latch
- Video: Review of Diamond Vehicle Lights - Replacement LED Bulbs - DI76VR
- Shop: RV Roof Membrane
- Shop: Vehicle Lights
- Search Results: license plate bracket
- Video: Review of Lippert RV Slide Out Parts - Venture Actuator Slide-Out Motor 18 To 1 Ratio - LC132682
- Q&A: Replacement Slide Out Motor For 2010 Gulfstream Sport Lite
- Q&A: Replacement Slide Out Motor and Gearbox for Thompson 7828696
- Q&A: Solution for Needing Replacement Gears of D-300 Klauber Slide Out Motor
- Video: Review of Lippert Components RV Slide Out Motor - LC387738
- Search Results: 132682
- Article: Trailer Wiring Diagrams
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Hitch
- Search Results: 44649