Where is the Retractable Height of the Pro-Series Pipe Mounted Jack Measure From
Question:
In the description it says Jack has 10-1/2inch retracted height. Where exactly is that measured from? I assume it is measured from the bottom of the foot plate to somewhere on the pipe mount. Any help would be greatly appreciated.
asked by: Dustin J
0
Expert Reply:
The 10-1/2 inch measurement that you referenced is the distance from the bottom of the foot bracket to the center of the mounting bracket.
I went out and measured it and shot a little video for you as well that I attached.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pro Series Round, Pipe-Mount Swivel Jack w/ Footplate - Sidewind - 10" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Pipe Mount
- Weld-On
- With Rectangle Foot
- Pro Series
more information >
Continue Researching
- Q&A: Replacement 12 inch Brake Assemblies for Dexter 36-89 on Trailer
- Q&A: Replacement Electric Brakes for Dexter PR-FF SEC-FF 5.2KPR-GGSEC-GG 12X2XQ 36-89
- Q&A: Equalizer Replacement Options for Dexter 13-122 Equalizer
- Q&A: Comparing Equa-Flex and Road Armor Equalizers For 2000 Forest River WIldwood W/ 5200lb Axles
- Q&A: Can 12 Volt Battery Replace Two 6 Volt Batteries
- Article: How to Rent an RV
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: Is LaSalle Bristol XTRM Universal Self-Leveling Sealant Comparable to Dicor Lap Sealant
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: What Exactly is Tongue Weight?
- Article: Most Popular Wheel Bearings
- Article: How to Charge a Dump Trailer Battery
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft