Bearing Replacements for 2004 Keiferbuilt Genesis X3 Horse Trailer
Question:
I have only owned this trailer for a short time. What size bearings and seals do I need for this size trailer. 2004 Keiferbuilt Genesis X3 - about 185inch and has duel axles. Thank you for your assistance.
asked by: Tom B
Expert Reply:
I looked up your 2004 Keiferbuilt Genesis X3 trailer and was able to find that it has a set of 5,000 lb tandem axles installed on it. The bearings for this axle capacity are normally # 25580 and # 15123. You can verify this by pulling the hub off of the trailer and checking the numbers stamped on them. Or you can measure the spindle where the bearings ride. If the diameter of the spindle where the bearings rid is 1.74 and 1.25 inch then that would indicate that the bearings mentioned are correct.
Product Page this Question was Asked From
Replacement Dome Assembly for Ventline Ventadome Trailer Roof Vent - White - Wedge Shape - Plastic
- RV Vents and Fans
- Replacement Lid
- Roof Vent
- 14W x 14L Inch
- Plastic
- White
- Ventline
more information >
Continue Researching
- Article: How to Charge a Dump Trailer Battery
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Article: How to Replace an RV Roof Vent Cover
- Q&A: Replacement Cover for Trailer Roof Vent AS-13 M-VD0449
- Q&A: Is There Down Side to Progressive Dynamics 4000 Series 60 Amp Over 45 Amp
- Q&A: Recommended Replacement For A WFCO WF-8750P Power Center
- Article: Trailer Hitch Receiver Sizes
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: 05680-C Master Cylinder Replacement for Trailer Recommendation
- Q&A: Replacement Leaf Spring Bolts and Bushings for Dexter 10K Axle On Big Tex Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Does Correct Track Trailer Alignment Kit # RR23QX Come with Enough Brackets for Tandem Trailer
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps