Does the Draw-Tite Class II Ball Mount # 3593 Use a 5/8 Inch Diameter Hitch Pin
Question:
Does this ball mount take a 5/8 dia pin hitch lock?
asked by: Jim G
0
Expert Reply:
Class I and II accessories like the Draw-Tite Class I Ball Mount you referenced all use a 1/2 inch hitch pin or lock. Class III, IV and V hitches use the thicker 5/8 inch diameter hitch pin or lock.
For your Class I accessory, I typically recommend a stainless locking hitch pin, like part # 40106.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Draw-Tite Drawbar for 1-1/4" Hitch - 2-1/8" Rise, 2-3/4" Drop - 6-5/8" Long - 2K
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 3/4 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 3 Inch
- Rise - 2 Inch
- Fits 1-1/4 Inch Hitch
- 2000 lbs GTW
- Class I
- Draw-Tite
more information >
Continue Researching
- Article: Trailer Maintenance Schedule
- Article: How to Charge a Dump Trailer Battery
- Q&A: Trailer Grease Seal to Replace 127194TB
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Mobile Home Axle Conversion to Electric Trailer Brakes
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Q&A: 205/75R14 Size Trailer Tire Needed with Load Range D and Speed Rating of at Least 81 mph
- Q&A: What Stops Porpoising on Tow Vehicle that is Using Weight Distribution with Trailer
- Q&A: How to Read the Lippert Components Axle Description Measurements
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Hitch Receiver Sizes