Direction of Handle to Open Valterra Waste Valve

Question

Question:

Which way is open? Pulled out or left shut to let waste water travel down sewer line?

asked by: Frank D

0

Expert Reply:

You will pull the handle on the Valterra Waste Valve for RV Black Water Tank # T58 "up" or "out" to let the waste water travel down the sewer line. When the handle is "down" or "in" it closes the line. I have attached some pictures for you to reference as well as a review video for you to check out.

expert reply by: Jon G

0

click to enlarge

Answer 1

If you want to install the Valterra Waste Valve #T58 in the side position it will absolutely acceptable, yes. In fact, the accompanying photo shows it installed in the same way as you are asking about. I've also added a link to a video review of…

view full answer...

Answer 2

I went out to the warehouse to measure the overall depth of the Valterra Twist-On Waster Valve, #T58, for you. It has an overall depth of 5-1/16 inches. I have included a picture showing this for you.

view full answer...

Answer 3

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 4

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 5

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 6

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 7

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 8

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

view full answer...

Answer 11

In order to match up the wheel studs for your Reliable 1206 hub, we'll need to know the full dimensions of the wheel stud you're replacing. In addition to the total length of the stud and its diameter and thread pitch, we'll also need to…

view full answer...

Answer 12

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Direction of Handle to Open Valterra Waste Valve

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching