Difference Between Replacement A and B Wheel Tray Assembly for Yakima TwoTimer Bike Rack
Question:
Hey, I am just wanting to learn the difference between tray assemblies A and B I think they are basically front and back depending on which side of the rack its mounted but wanted to make sure. Thanks!
asked by: Nolan
Expert Reply:
According to Yakima, the difference between the Replacement "A" Wheel Tray Assembly # 8880796 and Replacement "B" Wheel Tray Assembly # 8880797 is the following: "Look at the base of the wheel cup and look at the cut out above the steel bracket. Cup 'A' has has two bumps in the cut out and cup 'B' has a single bump."
If that was confusing to you, don't worry, it was confusing to me too, so I went and took a look at the "A" assembly. What I found was that at the bottom of the wheel tray where the shank of the bracket is you can see the "bumps" they are referring to, as you can see in the accompanying photo.
If you take a look at your wheel tray assembly you can use this photo and compare it to see which replacement is correct for you; if yours has 2 bumps you will need Replacement "A" Wheel Tray Assembly # 8880796. If it has just 1 bump you will need Replacement "B" Wheel Tray Assembly # 8880797.
Additionally, these wheel trays do not come with the strap so if you need that as well it is the Replacement Wheel Strap # Y8880229.
These wheel tray assemblies fit the Yakima FourTimer Bike Rack # Y02469.
Products Referenced in This Question
Replacement "A" Wheel Tray Assembly for Yakima TwoTimer and FourTimer Bike Racks - Qty 1
- Accessories and Parts
- Hitch Bike Racks
- Wheel Holds
- Wheel Trays
- FourTimer
- TwoTimer
- Yakima
more information >
Replacement Wheel Strap for Yakima Roof or Hitch Bike Racks - 12-1/4" Long
- Accessories and Parts
- Hitch Bike Racks
- Roof Bike Racks
- Straps
- Forklift
- Frontloader
- HighSpeed
- HighRoad
- HoldUp
- FourTimer
- TwoTimer
- Yakima
more information >
Product Page this Question was Asked From
Replacement "B" Wheel Tray Assembly for Yakima TwoTimer and FourTimer Bike Racks - Qty 1
- Accessories and Parts
- Hitch Bike Racks
- Wheel Holds
- Wheel Trays
- FourTimer
- TwoTimer
- Yakima
more information >
Continue Researching
- Shop: Replacement "A" Wheel Tray Assembly for Yakima TwoTimer and FourTimer Bike Racks - Qty 1
- Q&A: How to Raise Hitch Mounted Bike Rack for Additional Ground Clearance
- Article: My Trailer Hitch Doesn't Fit
- Article: Best Bike Racks for Electric Bikes
- Article: What Size Generator Do You Need to Run an RV Air Conditioner?
- Article: How to Tie Down a Canoe To a Roof Rack
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Troubleshooting Solid Blue Light on Curt Echo Brake Controller
- Q&A: Curt C51180 Echo Wireless Brake Controller Displaying Flashing Blue LED
- Article: Pintle-Hitches
- Q&A: Replacement Front Wheel Holder for Yakima HoldUp Platform Bike Rack
- Q&A: Installation Location of Tuson Electronic Sway Control for Electric Trailer Brakes
- Q&A: How to Remove 7-Way Trailer Wiring Plug from Socket on 2015 Audi Q7 with Factory 7-Way