Will the Plunger and Rubber Socket Door Holder PLR62-66 Work On a Motorhome
Question:
Would this work for a motorhome door?
asked by: Raegan M
0
Expert Reply:
Yes, I don't see any reason at all as to why the Plunger and Rubber Socket Door Holder part # PLR62-66 would not work with the door on your motorhome. It is designed for an enclosed trailer door which would be much heavier than the one on your motorhome so I don't think you will have any issues.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Plunger and Socket Trailer Door Holder - 1-3/4" Plunger - Zinc Plated Steel
- Trailer Door Holders
- Plunger and Socket
- 1-3/4 Inch Plunger
- 2-1/2 Inch Hole Spacing
- Rubber
- Polar Hardware
more information >
Continue Researching
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What is the Difference Between 7-Way RV and Utility Trailer Connectors
- Q&A: Recommended RV Exterior Ladder for 22 Ft Thor Four Winds RV
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Installation of Hitch on Fifth Wheel Trailer
- Q&A: How Much Upward Bend Should Trailer Axle Have
- Q&A: Is Bow in 3,500 lb Trailer Axle Enough Camber for Loaded and Unloaded Trailers
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams