Is Trailer Battery Being Able to Backfeed to Truck Battery a Problem
Question:
I’m wiring in a winch to my gooseneck. Wired my winch to battery, from battery to 7 gang box under trailer to maintain battery while truck is hooked up but naturally I’m now getting 12.5 volts dc at end of my plug. That won’t back feed into my truck and cause problems?
asked by: Daikin
Expert Reply:
In order for your truck battery to be able to charge your trailer battery it will have to have a connection to it that is going to have voltage like you tested. What you have is normal and the only possible downside would be if your trailer battery is basically dead and your truck battery ends up draining itself (if left connected for a long time) trying to charge it. When two batteries are connected they will seek to equalize the voltage between them.
Some truck 12 volt accessory circuits are active only when the vehicle is on and others all the time. If yours is all the time you can wire in a isolation solenoid part # PK5231201 which will only allow it to function when your key is on.
Products Referenced in This Question
Starter Solenoid - SPST - 12 Volt - 100 Amp - Continuous Duty - Grounded
- Accessories and Parts
- Battery Boxes
- Switches and Solenoids
- 100 Amp
- Pollak
more information >
Product Page this Question was Asked From
7-Way Round RV Style Trailer Connector - Trailer Side
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- Plug Only
- 7 Round - Blade
- Optronics
more information >
Continue Researching
- Shop: Ladder Rack
- Shop: Tonneau Cover
- Video: BAK Revolver X4s Hard Tonneau Cover Review
- Shop: Thule TracRac SR Sliding Truck Bed Ladder Rack - 1,250 lbs
- Shop: BAK Revolver X4s Hard Tonneau Cover - Roll Up - Aluminum and Vinyl - Matte Black
- Shop: Thule TracRac SR Sliding Truck Bed Ladder Rack w/ Cantilever - 1,250 lbs
- Shop: RetraxPRO MX Hard Tonneau Cover - Retractable - Aluminum - Matte Black
- Shop: RetraxPRO MX Hard Tonneau Cover - Retractable - Aluminum - Matte Black
- Shop: Starter Solenoid - SPST - 12 Volt - 100 Amp - Continuous Duty - Grounded
- Shop: Adarac Pro Series Custom Truck Bed Ladder Rack - Aluminum - 500 lbs
- Video: PowertraxPRO MX Hard Tonneau Cover Review RT90222
- Q&A: Can I Add the NOCO Genius On-Board Battery Charger to a System with an Existing Charger
- Q&A: What Gauge Wire and Fuse Should be Used to Install Bulldog A-Frame Trailer Jack BD500187
- Search Results: ramps
- Search Results: hitch receiver extension
- Search Results: hitch extender
- Search Results: 11~609
- Search Results: 2923
- Search Results: 6 pole square
- Search Results: e4541
- Video: ProGrip Tie Down Straps - Trailer - 317-18900 Review
- Q&A: How to Prevent Trailer Battery From Backfeeding to Vehicle Battery
- Q&A: Troubleshooting Trailer Battery Backfeeding Into Truck Lights
- Q&A: Brake Wire Backfeeding to Light on 7-Way
- Q&A: Troubleshooting Intermittently Working 7-Way Trailer Connector on 2011 Chevy Traverse
- Q&A: Trailer Wiring Diagram for a 7-Way Trailer Side Connector
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: Trailer Wiring Diagrams
- Video: Roadmaster Single Park Light Diode Installation - 2012 Jeep Grand Cherokee
- Video: Review of Excel RV Water Heaters - Tankless Ventless Water Heater - EX93FR