Troubleshooting Stromberg Carlson Electric Trailer Jack # JET-3555 That Stopped Working
Question:
It worked a few times but I raised it to the line on the bottom and it stopped. Then it quit working. It works with the manual tool. How do I get it working again? Please help
asked by: Mark J
0
Expert Reply:
Most likely you blew a fuse in your Stromberg Carlson Electric Trailer Jack # JET-3555. Check the yellow fuse holder that is on the main power wire of the jack as that is most likely the issue. This jack is somewhat known for being easier to blow fuses than other jacks.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 24" Lift - 3,500 lbs - White
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 24 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Best Solution For Gaining Tail Gate Clearance On A-Frame Trailer Tongue Jack
- Q&A: What is the Distance from the Mounting Surface to the Top of Electric Trailer Jack # JET-3555
- Q&A: Can Generator Be Ran While Installed on MORryde RV Generator Slide Out Tray
- Q&A: Fuse Location for 12-Volt Accessory Feed to 7-Way Trailer Connector on 2005 Chevy Silverado
- Q&A: Retracted Height of Stromberg Carlson Electric A-Frame Trailer Jack JET-3555
- Q&A: Quieter RV Water Pump Recommendation
- Q&A: Trailer Jacks Manufactured in the USA
- Article: Best Camper Jacks
- Article: Trailer Wiring Diagrams
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: What is an RV-Approved Bike Rack? (And Do You REALLY Need One?)
- Article: Performance Chips and Modules
- Article: Trailer Jacks
- Article: How to Raise Your Travel Trailer Height