Is Spacer Needed to Fit Double RV Waste Valves # T80A to 3-1/2" Inside Diameter Outlet
Question:
The black water tank has a 3.5 inch inside diameter outlet. Is there a spacer available to make up the difference?
asked by: Jeff
Helpful Expert Reply:
You actually don't need a spacer to attach the Double RV Waste Valves # T80A to your current black water tank. Since you are measuring 3-1/2" for your outlet you have a hub. The 3" spigot end on this double waste valve has an outer diameter of 3-1/2" so it will fit perfectly in the hub of your current setup. In regards to the 3" measurement, that is actually the inner diameter of the pipe itself. If you measure past the hub fitting on your line you should see that it measures 3".
Product Page this Question was Asked From
Double RV Waste Valves - Elbow - Rotating - 3" Spigot and 1-1/2" Hub to 3" Lug
- RV Waste Valves
- Sewer Elbow
- Double Waste Valve - Manual
- 1-1/2 Inch Hub
- 3 Inch Spigot
- Rotating Valve
- Valterra
more information >
Continue Researching
- Q&A: Water Heater Replacement for Atwood GC10A-2
- Shop: MORryde Premium Rubber Suspension Kit for Triple Axle Trailers w/ Correct Track - 33" Wheelbase
- Article: How (and Where) to Connect an RV Propane Grill
- Q&A: Dimensions of the Double RV Waste Valves # T84
- Q&A: What is the Difference Between Valterra Double RV Waste Valves # T80, # T80C, and # T80A
- Q&A: Correct Replacement for Voyager AOM713 Monitor
- Q&A: Replacement Circuit Board for MaxxFan Roof Vent 5100K
- Q&A: Differences Between Three Valterra Double RV Waste Valves
- Q&A: Is There a Difference Between the Valterra Double RV Waste Valves and Bristol Double RV Waste Valves
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Motorhome Steps
- Article: Replacement Automotive Lighting
- Article: Trailer Maintenance Schedule
- Article: Trailer Couplers
- Article: My Trailer Hitch Doesn't Fit