Where is the Best Place to Attach the 12 Volt Input for the Battery Isolation Solenoid
Question:
I just buy a solenoid PK5231201, and i want to now what is the amp i need to push to my solenoid to open it it let pass the 12 volt on the main . I understad that is 12 volt but its to calculate the wire size to go from my ing under the dash to the solenoid. thanks!!
asked by: Jonathan
Expert Reply:
The battery isolation solenoid itself, # PK5231201, is rated for a maximum of 100 amps, but you will not need that much on the 12 volt circuit that powers the unit. The techs suggest that the middle terminal should be attached to an ignition switch wire. That will carry the correct voltage and amperage needed. Typical 10 or 12 gauge wire will work. You do not want to go too small depending on the distance the power source is from the solenoid.
Product Page this Question was Asked From
Starter Solenoid - SPST - 12 Volt - 100 Amp - Continuous Duty - Grounded
- Accessories and Parts
- Battery Boxes
- Switches and Solenoids
- 100 Amp
- Pollak
more information >
Continue Researching
- Shop: Wagan Mobile Power Inverter - AC Outlet and USB Port - 1,000 Watts
- Video: Wagan 1000 Watt Power Inverter Review
- Q&A: Connecting Trailer Battery to Same 12 Volt Wire that Charges Breakaway Battery
- Q&A: How Long Will Battery of Bright Way Trailer Breakaway Kit Last
- Shop: Replacement 12V 5 Ah Battery for Bright Way Trailer Breakaway Kits
- Search Results: battery
- Search Results: inverter
- Video: Wagan 12V Power Accessories - Power Inverter - WC3720 Review
- Video: Review of Progressive Dynamics RV Inverters - 1,000 Watts Pure Sine Wave Inverter - PD34FR
- Shop: Progressive Dynamics 1000 Watt Pure Sine Wave Inverter
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Q&A: How To Power Small AC Household Electronics In A Van Without Using Solar Power Or A Generator
- Q&A: How to Connect Series-Wired Batteries to Power Inverter
- Video: Redarc Tow-Pro Elite Trailer Brake Controller Installation - 2017 Jeep Wrangler Unlimited
- Shop: Brake Controller
- Shop: Redarc Tow-Pro Elite Brake Controller - Dash Knob - 2 Braking Modes - 1 to 3 Axles - Proportional
- Q&A: How Does Battery Isolation Solenoid Wire Up to Prevent Vehicle Battery Drain
- Article: Determining Trailer Tongue Weight
- Q&A: Getting Power to 12-Volt Accessory Pin on 7-Way Trailer Connector
- Q&A: Installing 7-Way and Wiring for Auxiliary Battery Charging
- Shop: Hopkins 7-Way Molded Trailer Wire Connector - 11' Long
- Video: Redarc Tow-Pro Elite Trailer Brake Controller Installation - 2020 Jeep Wrangler Unlimited
- Shop: Reese Weight Dist Shank - 12-1/4" Long - 2" Drop to 6-1/2" Rise - 1,500 lbs TW
- Video: Review of Optronics Wiring - Wiring Clip - AZPCLB
- Shop: Trailer Hitch
- Search Results: 44649
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Choosing the Right Brake Controller
- Search Results: 25580
- Article: Trailer Wiring Diagrams