Slide Out Switch for Camper Trailer

Question

Question:

We have a 29 foot 2006 Forest River Wildwood camper. Do you have a replacement slide out switch that would work for us?

asked by: Melissa W

0

Expert Reply:

There is no way to know for us to know the exact slide out you have on your 2006 Forest River Wildwood and switches aren't made for specific campers, they are made for the slide out.

So if your Wildwood has a LCI (Lippert Components) Above-Floor or Through-Frame Slide-Out then we do have a switch that will work for you, the Lippert Components Slide-Out Switch Assembly - Black # LC117460 or White # LC117461.

expert reply by: Kyle S

0

Answer 1

Are you having a problem with your relay/switch blowing when installing a new switch? This is a common issue with the switches like the part #LC117461 and the problem is not the amperage rating and is actually the pin out of the relay as some…

view full answer...

Answer 2

I do not ahve the abilty to pull an OEM build sheet for part numbers however, we have a couple options available. The Single Slide-Out Switch, #37212285 is a 12V 40-amp continuous/momentary switch assembly. With cutout dimensions of 1.85"…

view full answer...

Answer 3

We have the Lippert Components Slide-Out Switch Assembly - Black #LC117460 or white #LC117461. As far as your motor goes, you will need to look at your assembly and give me the number on your assembly for the correct replacement. I've linked…

view full answer...

Answer 4

My contact at Lippert Components advised that their Interior Slide-Out Switch #LC120639 does indeed have three male tabs on the rear surface for electrical connection to your RV's slide-out.

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 8

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 9

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 10

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 11

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...

Answer 12

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Slide Out Switch for Camper Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching