Why is Valterra EZ Valve Electric Waste Valve Tripping Breaker
Question:
I had purchased a valve and it seemed to get something hung in the blade and trips circuit breaker..Have you heard of this happening before? Thanks
asked by: John M
0
Expert Reply:
Something getting hung up would not trip a circuit breaker on the Valterra EZ Valve Electric Waste Valve for RV Black Water Tank # E40B-8. If you are having an issue with the breaker getting tripped the issue is almost certainly going to be because the circuit you are wired to is pulling more amps it is capable of. This valve pulls 2.5 amps so you may want to try and wire it directly to a battery if possible.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Valterra EZ Valve Electric Waste Valve for RV Black Water Tank - 3" Hub to 3" Hub
- RV Waste Valves
- Straight Valve
- Single Waste Valve - Electric
- 3 Inch Hub
- Stationary Valve
- Valterra
more information >
Continue Researching
- Q&A: Can Center Section of Electric Waste Valve E40B-8 Replace Manual Setup
- Q&A: Troubleshooting Reese Electric Brake Controller That Displays OL Overload Code
- Q&A: Replacement Thermostat for Dometic 3316410.012 Thermostat
- Q&A: Replacement Water Heater for Atwood GC10A-3E
- Q&A: Replacement Trailer Clearance Lights PM-108-15 SAE-AP2-79
- Q&A: Switching From Manual To Powered Mode On The Valterra EZ Valve Electric Waste Valve
- Q&A: Are Tongue Weight, Hitch Weight and Pin Weight The Same Thing For a Fifth Wheel Trailer
- Article: How Does an RV Water Pump Work?
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Wiring Diagrams