Finding Reverse Light Circuit in 2016 Jeep Renegade to Install 4-Way to 5-Way Adapter
Question:
I have a 2016 Jeep Renegade and have a 4 pin flat setup but I want reverse lights as well. I have ordered the 4 to 5 pin adapter that splices into the reverse light. My question is which wire is the reverse light and do I have to tap leads from both the drivers side and passenger side in order to balance the load?
asked by: Chris
Expert Reply:
I wish I could tell you which exact wire you'd need to splice into for the reverse light circuit of your 2016 Jeep Renegade but since we have not installed a 5-way adapter like the part # 20036 to a vehicle like yours the best we can do is to have you test all of the wires that run to the reverse lights with a circuit tester like part # PTW2993 until you find the circuit that carries 12 volts only when the vehicle is in reverse.
Products Referenced in This Question
Product Page this Question was Asked From
Tow Ready 4 Pole to 5 Pole Trailer Wiring Adapter
- Trailer Wiring
- Wiring Adapters
- Single-Function Adapter
- 0 - 5 Feet Long
- 4 Flat
- Plug and Lead
- 5 Flat
- Tow Ready
more information >
Continue Researching
- Q&A: Can a 4-Way Trailer Connector be Plugged Into a 5-Way Vehicle End Trailer Connector
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Adding Reverse Lockout to Trailer with Titan Model 60 Actuator
- Q&A: Best 4-Way Trailer Wiring Harness For 2024 Toyota RAV4
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Parts Needed to Install 5-Way on 2019 Toyota RAV4
- Q&A: What is the Function of the 5th Pin on a Trailer Connector 5-Way Flat Connector
- Q&A: What Colors are Trailer Brake Magnets Wires
- Q&A: Do the Colors of Trailer Brake Magnets Mean Anything
- Article: Trailer Maintenance Schedule
- Article: How to Measure Your Trailer Wheel Bolt Pattern