Trailer Hub Not Going All the Way Back on the Spindle
Question:
I have an 8x16 Horton enclosed trailer 2004 year dual axel 3500 lb load. The wheel bearings went out on one axel on only one side. I reinsalled new bearings and grease seal, but the hub will not go all the way back on the spindle. I have double checked and the races and bearings are installed the right way, the spindle is not damaged, can you give me an idea where to check for problems. it lacks about 3/4 to 1 inch of going on all the way.
asked by: Guy
Expert Reply:
Assuming your spindle is ok, you need to double check your bearings and grease seal to make sure they are correct. If you are only 3/4 inch - 1 inch off, it is likely that the inner diameter of the grease seal is not large enough, thus not allowing it to seat onto the spindle properly.
