Roof Vent Cover For 2017 Viking Wolf Pup
Question:
vent cover is cracked it is a 14x14 Hengs with the hinge riveted on with 4 rivets on hinge and two on rod holder. Can I buy a 14x14 cover drill out the rivets and bolt it on...OR just contact cement it to the existing cover?
asked by: TERRENCE L
0
Expert Reply:
If you would like to bolt a new cover onto the roof vent like part # BV0554-01 you can but it may leak. If you concrete the hinge to your existing cover it could work but may be an issue with the hinge working properly. I have attached a photo of the most standard hinges on roof vent lids. If you send me a photo of your existing lid, it may be easier to compare.
expert reply by:
Heather A
0
Product Page this Question was Asked From
Vent Cover for Ventline Old Style Rounded Dome Trailer Roof Vents - White
- RV Vents and Fans
- Replacement Lid
- Roof Vent
- 14W x 14L Inch
- Plastic
- White
- Ventline
more information >
Continue Researching
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Article: Trailer Maintenance Schedule
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Article: Trailer Wiring Diagrams
- Q&A: Location of Heating Element on Atwood GC6AA-10E Water Heater
- Q&A: Troubleshooting 6 Gallon Atwood Water Heater Not Working on Electric But Works on LP
- Q&A: Should the Tires Lift Off the Ground While Leveling With the Lippert Ground Control Leveling System
- Q&A: Trailer Wiring Harness Recommendation for a 1999 Isuzu NPR
- Q&A: Best Weight Distribution for a V-Nose Trailer with Short Frame Distance from Coupler to Body
- Article: How to Replace an RV Roof Vent Cover
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: RV and Camper Types, RV Classes
- Article: Rooftop Cargo Carriers