Easy to Install Trailer Hitch for 2011 Cougar 24.5 5th Wheel with 4 inch Square Bumper
Question:
Hi. I have a 2011 cougar 24.5 5th wheel. my question is, how do I get around my sewer tube bumper? The bracket that comes with hitch looks like only s 2x2 receiver 3. My in place bumper is 4.5inch below the frame. If I am looking at this right I will need to cut a notch in my bumper and new hitch would be up into inplace bumper approx. 1.5inch If I do this I dont think my sewer pipe will fit in the bumper. I could slide mounting brackets towards the front and miss the in place bumper then I would need some type of adapter to 2x2 opening 1.5inch below my bumper then need an extension out to be close to flush with and below my in place bumper. Do you have any suggestions on how to install so I do not have to cut my in place bumper?? Thank you,
asked by: Scott J
Expert Reply:
Sounds like you have the standard 4 inch square bumper at the back of your 2011 Cougar that is getting used to store your sewer pipe. The easiest hitch solution actually will be to go with a hitch that installs on the bumper like the Curt # E-100. This easily installs over the bumper with the included hardware and has towing capacities of 3,500 lbs trailer weight and 350 lb tongue weight. I attached a picture that shows what the hitch looks like installed as well as review video. This won't interfere with your sewer storage and will give you a hitch opening that's much easier to access than one that would be recessed quite a bit behind the bumper.
Products Referenced in This Question
Curt RV Bumper 2" Trailer Hitch Receiver
- RV and Camper Hitch
- Bumper Mount Hitch
- 4 x 4 Inch Bumper
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- CURT
more information >
Product Page this Question was Asked From
Adjustable Width Trailer Hitch Receiver for RVs, 22" to 72" Wide
- RV and Camper Hitch
- Frame Mount Hitch
- 22 - 72 Inch Wide Frame
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- Weld-On
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Will the Draw-Tite Trailer Hitch Fit a 2022 Volvo XC90 Recharge
- Article: Trailer Wiring Diagrams
- Q&A: Typical Trailer Suspension Hanger Spacing Relative to Leaf Spring Size
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: Best Upgrade for Dometic 310 Part-Timer RV Toilet
- Q&A: How To Connect A Dometic 310 RV Toilet To A Supply Line That's Too Far Away
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: Replacement Lift Motor for Fantastic Vent in 2002 Teton 5th-Wheel Trailer
- Q&A: How To Activate 12V Trailer Charge Circuit On 2019 Ford Super Duty With Factory 7-Way
- Article: 2023 Best Gifts for Outdoor Enthusiasts
- Article: How Harvest Hosts Is Becoming the New Standard of the Camping Industry
- Article: How to Replace or Install an RV Roof Vent