Weight Distribution Recommendation for 2017 Winnebago Micro Minnie 1700BH
Question:
We are wanting to add a weight distribution system to our 2017 Winnebago Micro Minnie 1700BH. We are pulling the trailer with a 2005 Ford F-150, with a maximum two weight of 500 lbs and the trailer has a GVWR of 3800 lbs. All that being said, I have been trying to determine which system to buy, and I am not quite sure which model would be best. So any help would be greatly appreciated.
asked by: Stacy K
Expert Reply:
The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached a help article on determining tongue weight for you to check out as well. You will want the loaded tongue weight of your setup to fall right in the middle of the tongue weight range of the system you use.
The best weight distribution for 500 lb tongue weight like you mentioned having would be the Reese Straitline system part # RP66083 which has a tongue weight range of 400-800 lbs and features the only sway control that works to fight sway before it starts.
For a 2 inch ball you would want part # A-90 and for a 2-5/16 inch ball # 19286.
Products Referenced in This Question
2-5/16" Hitch Ball - 1-1/4" Diameter x 2-3/4" Long Shank - Chrome - 12,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2-5/16 Inch Diameter Ball
- 2-3/4 Inch Shank Length
- 1-1/4 Inch Diameter Shank
- 12000 lbs GTW
- Class IV
- Class V
- Draw-Tite
more information >
2" Hitch Ball - 1-1/4" Diameter x 2-5/8" Long Shank - Chrome - 10,000
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2 Inch Diameter Ball
- 2-5/8 Inch Shank Length
- 1-1/4 Inch Diameter Shank
- 10000 lbs GTW
- Class IV
- Class V
- CURT
more information >
Strait-Line Weight Distribution System w/ Sway Control - Trunnion Bar - 8,000 lbs GTW, 800 lbs TW
- Weight Distribution Hitch
- WD With Sway Control
- Some Sway
- Includes Shank
- Electric Brake Compatible
- Fits 2 Inch Hitch
- Allows Backing Up
- 500 lbs
- 600 lbs
- 700 lbs
- Reese
more information >
Product Page this Question was Asked From
Fastway e2 Weight Distribution w/ 2-Point Sway Control - Round - 10,000 lbs GTW, 1,000 lbs TW
- Weight Distribution Hitch
- WD With Sway Control
- Some Sway
- Includes Shank
- Electric Brake Compatible
- Surge Brake Compatible
- Fits 2 Inch Hitch
- Allows Backing Up
- 700 lbs
- 800 lbs
- 900 lbs
- Fastway
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Replace or Install an RV Roof Vent
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: How Do I Measure the Drop Distance on a Trailer Drop Axle?
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: Correct Weight Distribution Hitch for Trailer With 7,000 lb GVWR
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Q&A: Will the Draw-Tite Trailer Hitch Fit a 2022 Volvo XC90 Recharge
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Replacement Disc Brake Caliper for a Tie Down Engineering 46304 Caliper
- Q&A: Recommended Surge Brake Compatible Weight Distribution System for a 3,000 lbs Trailer
- Q&A: Replacement For Dexter DX12.5 Brake Actuator on Boat Trailer
- Article: Determining Trailer Tongue Weight
- Article: How to Measure for Trailer Hitch Drop
- Article: Best Hitches for Travel Trailers (2022) - For a Smooth, Sway-Free Ride