Will a SportRack Vista XL Cargo Box Fit on a 2011 Chrysler Town and Country

Question

Question:

Will the SportRack Vista XL Cargo Box, part#: SR7018 work on my 2011 Chrysler Town and Country with factory installed roof rack system?

asked by: Jennifer M

0

Expert Reply:

As long as the diameter of the crossbars on your 2011 Chrysler Town and Country are less than 4 inches and are 25-7/8", 27-7/8", or 29-7/8" apart on center this SportRack Vista XL Cargo Box # SR7018 would work for you.

expert reply by: Jameson C

0

Answer 1

I have a solution for you, but the discontinued SportRack SkyLine XL Cargo Box SR7095 that you referenced would only fit crossbars that are 21-1/2 inches apart. Since the crossbars on your 2015 Chrysler Town and Country are fixed at a wider…

view full answer...

Answer 2

If you are looking for a box that will not interfere with the rear hatch on your 2010 Chrysler Town and Country then from Thule the best option is the Motion, #TH629706. The Force XL boxes have not been confirmed to fit without interfering with the…

view full answer...

Answer 3

I checked with Yakima, and the Skybox 18 Roof Top Cargo Box will fit your 2008 Jeep Commander with the factory cross bars. The cross bars must be situated between 24 and 48 inches apart.

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 9

The Replacement Amber Lens for MC32AB Trailer Lights #A32AB is a direct replacement for the SAE A P2 DOT 14 and would be what you'd need.

view full answer...

Answer 10

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 11

As far as height adjustability and weight capacities the Curt Q20 #C16130 and the Curt A20 #C16140 are identical. They both have a Gross Towing Weight of 20,000 lbs, a Vertical Load Limit of 5,000 lbs, and a height range of 13-17 inches. When it…

view full answer...

Answer 12

Yes, the best option we can offer you to add fuel capacity is with the DeeZee Truck Bed Auxiliary Tank part #DZ91752X which should fit in the space you have between the cab and 5th wheel hitch no problem as it is only 9" deep. I don't have…

view full answer...

Will a SportRack Vista XL Cargo Box Fit on a 2011 Chrysler Town and Country

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching