How Does Brake Controller Wire to 2009 Chevy Silverado
Question:
Hello. I bought a used 2009 Chevrolet Silverado 1500 LS. It has a hitch and 7 way installed in the bumper so it looks factory. The 7 way is wired and runs up towards the cab of the truck before I lose it. I look under the dash and can’t seem to find any wires to install a brake controller. There is a transmission temp gauge in the digital display so I’m assuming it had a tow package. Any help on where I might locate the wires or what I need to have trailer brakes?
asked by: Brad B
Expert Reply:
Your 2009 Chevy Silverado is supposed to have 4 blunt cut wires under the dash for you to use to install a brake controller like our very popular P3 part # 90195. Below the steering column, there is a bundle of wires tied together with white tape, located left of the brake pedal. This bundle of wires is the tow package for the brake controller. Carefully cut the white tape binding the wires, and pull the wires down from underneath the steering column.
Connect the four wires on the brake controller adapter to the tow package wires. Follow the table below to connect the tow package wires and adapter wires using butt connectors.
I also attached an install video link that shows a brake controller installed in a 2009 Silverado just like yours.
Products Referenced in This Question
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Choose the Right Trailer Hitch Class
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: What is the Difference Between the Tekonsha Prodigy P2 and the P3 Brake Controllers
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Recommended Dexter Suspension Kit 7753400