Roof Rack Recommendation for 2017 Subaru CrossTrek for 120 lb Boat

Question

Question:

I have a 2017 Subaru CrossTrek, and I am looking for a relatively inexpensive roof rack that would allow me to transport a Sunfish sailboat. The boat hulls overall length is around 14 feet, and it weighs around 120 pounds. Id estimate another 20 pounds for its mast and booms, which are approximately 10 feet in length. Do you think this is possible with the 50 or 58-inch Malone rack, for example?

asked by: Kenzie

0

Expert Reply:

For your 2017 Subaru Crosstrek we have the Malone Roof rack part # MPG202 which has a weight capacity of 165 lbs. This rack would easily have the capacity for a 120 lb boat but you'd also want to check the owners manual of your vehicle to verify that it also has the needed weight capacity.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The biggest improvement you can make in handling and stability for motorhomes built on a 2017 Ford F-53 chassis is with a rear sway bar like the part #RM-1139-146 which is correct for your motorhome and your 18k GVWR. Next up you'd want to…

view full answer...

Answer 2

From my available research on your 2021 Georgetown 36b5 motorhome, it has a Ford F-53 chassis and has a gross vehicle weight rating of 22,000 pounds. Unfortunately, for this particular model, we do not have a steering stabilizer available for your…

view full answer...

Answer 3

Of the options mentioned I like the Malone SteelTop Roof Rack part #MPG201 the most for what you are trying to accomplish. The SportRack bars were a little thinner but most accessories do not have issues when swapping them over to the 1 1/4"…

view full answer...

Answer 4

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 7

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 8

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 11

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 12

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Roof Rack Recommendation for 2017 Subaru CrossTrek for 120 lb Boat

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching